Unitech MS840B Manual do Utilizador descarregar pdf (Página 27)

2. Insert another dongle into a

USB port of the computer or

laptop PC.

3. Scan the MAC address of

the dongle by using the

MS840B scanner.

4. When being successfully

connected to the dongle, the

scanner will beep shortly one

time with a high tone.

Memory Buffer Setting

The collected data can be sent back to a host computer one by one via the WPAN

connection as the scanner is set to the Batch Mode, or can be stored in the flash

memory of the scanner being set to the Inventory Mode.

By default, the Batch Mode is enabled for use when the scanner is out of range.

Upon reading a barcode successfully within range, the scanner responds with one

short beep (high tone) and its LED indicator becomes solid green and goes off

B transmit buffer, the scanner can ignore the

on reading barcodes until the buffer is full.

d and the scanner is out of range, the scanner will

respond with two short beeps, high-low tone, upon reading a barcode successfully.

When the memory buffer is full, the scanner will respond with one long beep (low

tone) and its LED indicator will become solid red and go off quickly. You are

advised to get back to range.

quickly. However, the host computer may not receive the data immediately i

getting out of range. With the 4 K

transmission status and keep

When the Batch Mode is enable

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 62 63

Sem comentários

Unitech MS840B Manual do Utilizador Página 27