Unitech HT630 Especificações descarregar pdf (Página 30)

How to Create a FormCaching

You will need to enter Supervisor Mode (see ‘Overview’

in Chapter 3 of this manual) and select the “4.FORM” category

in order to set the conguration of FormCaching.

After selecting the “4.FORM” in Supervisor Mode,

(the screen should match the diagram to the right), the system will ask you to specify

four categories of the eld specications (eld prompt, data length, data type and

device type) of each data eld.

This step also determines the number of elds in each record. After dening all data

elds, press to end the setup of eld specication. Or, you may also continue to

set the last six categories including between eld, eld delimiter, record delimiter, date

stamp eld, time stamp eld and eld delay.

When the FormCaching application is executed, a data le named FORM.DAT will be

created to store the data. The system will not allow the user to redene FormCaching

if a FORM.DAT le currently exists. It is necessary to delete the FORM.DAT le in

order to change the conguration of FormCaching.

How to Run FormCaching

When FormCaching is enabled, the built-in application can be started by selecting

the “2.TER” command in User Mode and then selecting “2.FORMCACHING”. The

FormCaching application will run and follow the dened settings.

All scanned and keypad input data is saved to the le named FORM.DAT. You may

use the

key to browse a previous data record, press to step to the next record,

and press to clear the record and then input a new value for every eld of this

record. Press to end FormCaching and return to System Ready Mode.

After collecting data, the FORM.DAT le can be uploaded to the PC/Host either

through PTComm Manager, uTransfer, the Kermit server in User Mode, or through a

remote ESC command.

FORMCACHING

1:YES

2:NO

OTHER:EXIT

1 2 ... 25 26 27 28 29 30 31 32

Sem comentários

Unitech HT630 Especificações Página 30