Unitech PA982 Manual do Utilizador descarregar pdf (Página 10)

Back View

Setting up the PA982

This section explains how to install and charge the battery, how to check battery status, how to connect

the PA982 to a PC, how to turn on the PA982 for the first time, how to install an optional Wireless Local

Area Network PCMCIA card, and how to calibrate the screen.

Installing the Battery

WARNING! There is a risk of fire and burns if the battery pack is handled improp-

erly. DO NOT disassemble, crush, puncture, short external contacts,

or dispose the battery pack in fire or water. DO NOT attempt to open

or service the battery pack. Dispose of used batteries according to

local recycling guidelines in your area.

A backup battery cell is embedded into your device to prevent data loss in instances when the remov-

able battery pack is removed or completely discharged. This backup battery cell will only support the

system for a maximum of 72 hours.

NOTE:

• To enable the internal battery cell to provide backup power supply, charge your

device with the main battery pack for at least 16 hours.

• The first time you use the PA982, you must turn on the backup battery switch.

• The first time you use the PA982, you must activate the LCD heater switch. When

activated, LCD heater will turn on automatically when the temperature is lower than

-10°C.

No. Component Description

10.

Battery compartment Houses the removable and rechargeable 7.4V 2200mAh

lithium-ion battery pack

11.

Reset button Press the end of the stylus into the button to reset your

device.

12.

Handstrap Enables you to securely hold the PA982 while using it.

13.

Right scanner trigger button Press to activate the barcode laser scanner.

14.

PCMCIA compartment Open this compartment to access the PCMCIA slot.

15.

Barcode scanner window Used to scan barcodes.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 33 34

Sem comentários

Unitech PA982 Manual do Utilizador Página 10